Derby Monkey Water Slide Pinewood Derby Decals are thinner than many other decorative Pinewood Derby decals and, since they are printed, can be produced to a very high level of detail. They are very easy to apply.

The large viper is almost 1¾″ wide… perfect for Pinewood Derby car bodies. The three smaller cobras and sinage are for detail.

These Pinewood Derby Decals are Available only at Derby Monkey Garage

Instructions:

1. Cut out the images as close as possible to the actual design
2. Trim to fit car body if necessary
3. Place in lukewarm water for 30 seconds or more
4. Hold the decal carefully to avoid tearing
5. Apply decal to a clean surface by sliding it into place
6. Use a clean damp paper towel to wipe off excess water
7. Remove any air bubbles that may appear
8. Allow setting time of 3 hours
9. Spray entire car body with clear enamel or lacquer