Pro Bore Polisher and Polish
Pro Bore Polisher and Polish

Our Price: $9.95

Quantity in Stock:(Out of Stock)

Product Code: 2017


Derby WorxInner hub treatment has been limited until now. Many times we have a good wheel, but it just dose not spin that well or lacks what others have. Now this can be corrected and good wheels can be made to spin even better than ever.

The Derby Worx Pro Hub Polisher and is designed to use a polishing media (Micro-Gloss Wheel Bore Polish and pipe cleaners are included) that is secured in a tool base for polishing the inner hub. By provide an equal pressure on the inner hub bore while being spun in a drill at a low speed, imperfections from molding are removed and break-in time of a new set of wheels is reduced. This helps in the mating of the surfaces of the axle to the hub.

• Pro Hub Polisher
• Gloss Bore Polish
• Two Fluffy Pipe Cleaners
• Instructions

The Pro-Bore Polisher cleans and polishes the wheel bore to minimize friction. In addition to the Pro-Bore Polisher,a pipe cleaner,1 micron plastic polish (included),a hand drill,and a clamp are required.

• Clamp the hand drill to a work surface using the clamp. Do not use a Dremel-type tool as the RPM is too high.
• Insert the solid shaft of the Pro-Bore Polisher into the chuck of the drill.
• Cut a piece of pipe cleaner 1-1/4” long.
• Slide the pipe cleaner between the two prongs of the tool. Make sure that the pipe cleaner is centered between the prongs.
Caution - Some polish may be thrown when the drill is running,so wear eye protection,old clothes,and cover any sensitive equipment on either side of the pipe cleaner.

• Apply a small amount of polish to the pipe cleaner. Spread the polish onto the entire pipe cleaner surface.
• Slide a wheel onto the pipe cleaner and over the tool.
• Hold the wheel and start the drill on a slow to medium speed.
• Move the wheel back and forth on the tool for 5 to 10 seconds.
• Slide the wheel off the tool onto the pipe cleaner and polish for an additional 5 seconds.
• Remove the wheel and stop the drill.
• Repeat steps 5 to 10 for the other wheels.
Important - Do not slide the wheel onto the Pro-Bore Polisher while the drill is running.

• Wash the wheels in water,using a clean portion of the pipe cleaner to scrub inside the bore.
• Dry the wheels. A dry portion of pipe cleaner can be used to dry inside the wheel bore

Average Rating: 5 of 5 Total Reviews: 1 Write a review »

  0 of 0 people found the following review helpful:
Pro Bore Polisher February 19, 2015
Reviewer: Andrew Wobser from Cincinnati, OH United States  
Easy to use

Was this review helpful to you?