Derby Monkey Water Slide Decals are thinner than many other decorative decals and, since they are printed, can be produced to a very high level of detail.

There are two decals that are exactly 1¾″ wide… perfect for Pinewood Derby car bodies.

Available only at Derby Monkey Garage

Instructions:

1. Cut out the images as close as possible to the actual design
2. Trim to fit car body if necessary
3. Place in lukewarm water for 30 seconds
4. Hold the decal carefully to avoid tearing
5. Apply decal to a clean surface by sliding it into place
6. Use a clean damp paper towel to wipe off excess water
7. Remove any air bubbles that may appear
8. Allow setting time of 3 hours
9. Spray entire car body with clear enamel or lacquer