Skins Pinewood Derby Water Slide Decal
This decal is perfect for a car that is somewhat flat on top. These are thinner than many other decorative decals and, since they are printed, can be produced to a very high level of detail.
This decal is the perfect size for Pinewood Derby car bodies.
Available only at Derby Monkey Garage
- Cut out the images as close as possible to the actual design
- Trim to fit car body if necessary
- Place in lukewarm water for 30 seconds
- Hold the decal carefully to avoid tearing
- Apply decal to a clean surface by sliding it into place
- Use a clean damp paper towel to wipe off excess water
- Remove any air bubbles that may appear
- Allow setting time of 3 hours
- Spray entire car body with clear enamel or lacquer